CIF Liner terms

A main bearing consists of two shells which are secured by means of studs and _____.

A:tie rods B:through bolts C:lead wires D:bearing caps

Bearing knocks are likely to occur from _____.

A:less clearance B:dirty lube oil C:overload D:bearing wear

The main bearing metal is a lining _____.

A:inside the bearing B:outside the bearing C:covering the crankshaft D:none of the above

Improper cooling of a diesel engine cylinder liner due to the accumulation of scale deposits may cause _____.

A:low compression pressure B:increased piston wear C:increased cylinder lube oil consumption D:poor contact between compression rings and liner

To guarantee that a reduction gear bearing is receiving proper oil supply, you should check the .

A:lube oil temperature at the cooler outlet B:lube oil strainer magnets bearing C:lube oil temperature D:lube oil pressure to the bearing

Which of the listed bearing types is an example of a solid bearing?

A:Piston wrist pin bushing B:turbine bearing C:Spring bearing D:Diesel engine main bearing

A properly honed diesel engine cylinder liner will________.

A:prevent piston ring wear B:shorten the ring break-in period C:prevent cylinder liner glazing D:appear slick and glazed

Which of the following statements concerning cylinder liner wear is true?

A:Liner wear is distributed equally between the upper and lower portions of the cylinder B:Excessive liner wear causes wear between piston ring and groove C:Excessive, but uniform liner wear will not cause wear between piston ring and groove D:Liner wear is normally greatest in the middle of the cylinder

A bronze bearing liner with a lead-tin flashing has a milky-white color over most of its surface and some areas of exposed bronze, the white coloring indicates________.

A:proper break-in wear B:improper break-in wear C:relocation of the overlay flashing D:water contamination of the lube oil system